DitoGear, a motion control company, no longer exists.
We do not have the expertise to repair any of their equipment, or tell you how to repurpose it for other uses.
If you have their DMC-16 adapters, those will also work with our DMC-32 and DMC+ RJ-45 outputs.
If you are brave or knowledgable, you can try to wire your DitoGear equipment up to our DMC-32 or dmc-lite.
Here is the pinout for single-axis Ditogear devices:
- CLK
- DIR
- SHUTTER
- GND
- GND
- RESERVE
- VCC
- VCC
Here is the pinout for double-axis Ditogear devices:
- PAN CLK
- PAN DIR
- TILT CLK
- GND
- GND
- TILT DIR
- VCC
- VCC
Please try to confirm this information, and be careful when trying to wire things up. We think that the VCC on these pins is not just 5V TTL, but that they are ‘injecting’ a higher voltage/current signal to actually power the motors.
We recommend getting some RJ45 breakout boards and examining the signals coming out of their controller.
Once you’ve sorted out the VCC lines, you should be able to align the DMC-32 RJ45 or dmc-lite output with the DitoGear input.
The signals they are calling “CLK” are what we call “STEP+”. Their “DIR” is our “DIR+”.